![]() And when I wanted to use it, say for example this was the material I was planning to cut and I’d set my file up to cut from the top of the material down – and the zero was on the top of the material, I would take the crocodile clip and hold it onto the bit. This is connected to the ground and this is connected to the signal. And this relays back to the control board. One is bolted onto the aluminium plate, and this is 1.5mm thick and there’s a crocodile clip on the other end. And when I required it I would plug it into this aviation panel mount here. It has an aviation panel mount socket at the end. So this is what I’ve been using to probe for some time now. Instead of G92 it is recommended to use a G10 Set Tool Offset / Programmable Data Input command instead. ![]() ![]() Note: G92 Position Register / Set Position commands will reset if a M30 command is executed at the end of a g-code job, or if the GRBL soft stop is pressed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |